Automatic check failed

[RedRocket]

Please remember that at least one sensor is broken:
"with front system used with rear sensors: when connected to rear sensors,no error message but only one sensor works as parking sensor. But both detect my laser tester."

Ok, we can use this, but don't use the Laser Tester,the output is to wide & not useful to draw conclusions for which sensor or cable is the bad one.

Use your hand instead- by placing it close (about 10mm) to each one, see if you get U-boat "ping" sound from each Rear sensor.

[syrinx]

With my hand, I see that one sensor doesn't work as parking sensor.

With the laser tester, I've hidden one by one the sensor with à piece of paper.

[syrinx]

(If 1 Sensor or 1 bad cable, the CPU Control Box may not permit a Factory Reset...I have never tried this w/ a problem existing in the system already !)

Instructions are already here on the Forum if you would look for them !

Here is the location for them:
http://www.radarandlaserforum.com/fo...hp/6-AntiLaser

Factory Default Reset:

Choose this Thread... "Sticky" Thread: "First Steps Required After Installing Your AL Priority System"

See Post #1- Find Step #4

I will try again because I did already this factory reset and I didn't see any improvement: same errors message with F2 which wasn't never used.

[syrinx]

syrinx, "IF" you did not want sensor cables inside your car and/or the original/standard cables were not long enough to reach from the ALP CPU (most likely placed under your dash) to your rear ALP sensors, you should have ordered two of the "AL Priority Sensor Extension Cables" @ $29.95 USD each.

I don't understand your idea, I don't want cables between front and rear of the cars. I can hear the front, I can hear the back, I don't have cables in view, it's what I want.

[modsl55amg]

I don't understand your idea, I don't want cables between front and rear of the cars. I can hear the front, I can hear the back, I don't have cables in view, it's what I want.

OK, you have what you want. Good Luck with troubleshooting the problem.

[RedRocket]

With my hand, I see that one sensor doesn't work as parking sensor.

With the laser tester, I've hidden one by one the sensor with à piece of paper.- Paper does not completely block Infrared photons, some can still pass through & some will scatter for the other sensor to receive & will cause alert. The AL-P sensors are very,very sensitive to receive a small amount of IR signal from the Tester.

1. Did you label the cables like I asked you to do ?
Just as you posted before when you started this Thread, what were the results you got when you looked at the ALP report like in your Post #1 ?

[syrinx]

Hello,

Thank for the factory reset. I succeed to do it. The CPU behave well now (I mean no error on a port which was never connected, used).

The cables have been labelled from the beginning. When I reverse the round ports, or when I reverse the RJ ports, I have always the same result: the right rear head is not working in parking mode, it detects my laser tester but it doesn't emit. It makes sense with the parking mode which is not working. I will dismount this head and send it for guarantee exchange.

Thank you very much for your support! The mess was from the CPU which was needing a factory reset.

[RedRocket]

Hello,

Thank you very much for your support! The mess was from the CPU which was needing a factory reset.

You're welcome, congratulations on finding your problem & getting it fixed.

[syrinx]

No answer from Radarmeister/Hugel66 for few weeks. Where can I send my dead sensor (from Europe)? Thanks.

[BestRadarDetectors]

No answer from Radarmeister/Hugel66 for few weeks. Where can I send my dead sensor (from Europe)? Thanks.

Contact the dealer who you purchased from. I am sure they must have a phone number.