New ALP CPU constantly beeping and red flashing led

[deano]

I never changed any leads on mine I installed my G9 heads with the original wiring ...I never even removed the G9 cable from the heads as I had heatshrink sealing them... I knew if I did remove the heatshrink it would of been put on the one of the do lists and known me I would of forgotton to re heat shrink

thats a pretty expensive mistake though they should start to mention this in manual

the shop here in morley when paul was running the show did a similer thing to his jammers ....while he was bench testing some GF100s he plugged in some heads into a different jammer cpu ....they worked on the bench so we went out installed them on a car and shot with the ultrlyte the jammer alerted but would not jam turned out to be a fried part in the CPU

[dinkydi]

I never changed any leads on mine I installed my G9 heads with the original wiring ...I never even removed the G9 cable from the heads as I had heatshrink sealing them... I knew if I did remove the heatshrink it would of been put on the one of the do lists and known me I would of forgotton to re heat shrink

thats a pretty expensive mistake though they should start to mention this in manual

the shop here in morley when paul was running the show did a similer thing to his jammers ....while he was bench testing some GF100s he plugged in some heads into a different jammer cpu ....they worked on the bench so we went out installed them on a car and shot with the ultrlyte the jammer alerted but would not jam turned out to be a fried part in the CPU

manufacturers, may be could put a lable on there leads, like use only on /or with,

also asking a question BRD, mentioned earlier,ext leads are straight through , but the pin out could be different, so best beware using diff ext leads as well ?. also be good if a short small converter ext, to allow for easy switching between various makes , save a full car re/wire

[BestRadarDetectors]

manufacturers, may be could put a lable on there leads, like use only on /or with,

also asking a question BRD, mentioned earlier,ext leads are straight through , but the pin out could be different, so best beware using diff ext leads as well ?.

Straight through would be pin 1 goes to pin 1, Pin 2 goes to pin 2, Etc. All you are doing is extending the cable length so it should not make any difference. You can verify this with a meter, I dont have any old G9 stuff so I cant test it for you.