ALP Sensor group firing question. ( Rear Set-Front Set)

[Fletch]

I had the same problem with my rear 5 sensors (poliscan)

I had front ports mounted on the left side rear all diff angles and my 2 rear ports on the right side rear diff angles

yes all sensors will work together

but I did have some issues while testing with some lidar guns I was picking out the same week points every time seem to happen if I tagged one side only and then panned to the right or vise versa without a new trigger pull on the lidar gun ..so we mixed all the ports around to try and trigger a chain reaction .... once we swapped and mixed ports it was JFG every time

ahh, so what you are saying is your testing then proved that unless both front and rear sensors pick up the same signal then they act interdependently, so in order to combat the possible isolated receives you mixed front and rear ports on the same side in such a way that both front and rear ports receive the same signal at the same time, ish, then all 5 sensors counter attack. ( i think i got you.)

Now i have to rethink all the angles as i need to have them cross over each other due to the extreme angles that Poliscan can perform

Then a future suggestion for this ALP firmware (in another thread at the moment i think) would be to have the ability to select the grouping rather than have them fixed in one group of 3 and another group of 2.

J.