AfterALp Firmware Update- system takes long time to go into defense mode.

[BestRadarDetectors]

Try reloading your setup file. Sounds like settings might have been defaulted so it's probably taking 60 seconds. Reload a setup file and choose skip first warmup.

Sent from my SM-G928T using Tapatalk

[enzom]

Try reloading your setup file. Sounds like settings might have been defaulted so it's probably taking 60 seconds. Reload a setup file and choose skip first warmup.

Sent from my SM-G928T using Tapatalk

I have reloaded the setup file and controller update three times from three different USB thumb drives and it will not load my settings. The flashing light is killing me at night.

[BestRadarDetectors]

I have reloaded the setup file and controller update three times from three different USB thumb drives and it will not load my settings. The flashing light is killing me at night.

Pull a Statistics file and email it to us. Either you are on an old firmware that does not support the dim feature or you are using an incompatible USB drive or the file names of the files are not the original names.

Sent from my SM-G928T using Tapatalk

[enzom]

Pull a Statistics file and email it to us. Either you are on an old firmware that does not support the dim feature or you are using an incompatible USB drive or the file names of the files are not the original names.

Sent from my SM-G928T using Tapatalk

It was working fine before this latest update. I had changed the setup to have a dim light, avoid the 60 second warm-up time, etc. I bought a new USB thumb drive. I will try again.