CRC Checksum Failed Message after Firmware Update

[BestRadarDetectors]

Hi radargeek, When I went to load the new Control Box firmware 5.2.5/6.8 last night (Uxxxxxxx.bin), I also had the three additional, newly generated, files on my USB flash drive. (UCSTHIFI.BIN, VOICEPCK.ALP, CONFIG.ALP). A few seconds after receiving the CHECKSUM FAILED verbal warning, I received DATA STORED. But I was not sure if all of the downloads were really complete, or if there was some type of an error in the download process. That is why I stopped, and asked questions on this Forum, before proceeding to perform a RESTORE DEFAULTS AND MEMORIZE SENSORS, then try the complete download again. The system gave me a DATA STORED within a couple of seconds after I inserted the USB flash drive, and everything on the PRINT USE STATISTICS AND DEVICE INFORMATION checked out to be identical to each of the three Configuration Profiles A/B/C.

You were fine.. There was nothing wrong with the firmware update and trying to install firmware again would just be ignored since you cant install new firmware if the installed version is the same or newer than what you are trying to load.