ALP errors, what's wrong with my device?

[RedRocket]

Only one sensor shows attached.if you had more than one sensor fail you need to inspect your wiring and make sure no wires are pinched or nicked.

Agree, something is seriously wrong if Sensors are failing like this, may be best to stop putting 12v power to the Priority until you completely check wiring and for bent pins in the connectors.

Unless you have some electrical/electronics experience in troubleshooting this problem, you need someone to help you that does have knowledge.- What State are you located ?

[lamster]

Only one sensor shows attached.if you had more than one sensor fail you need to inspect your wiring and make sure no wires are pinched or nicked.

Sent from my SM-G935T using Tapatalk

Agree, something is seriously wrong if Sensors are failing like this, may be best to stop putting 12v power to the Priority until you completely check wiring and for bent pins in the connectors.

Unless you have some electrical/electronics experience in troubleshooting this problem, you need someone to help you that does have knowledge.- What State are you located ?

Im graduated with an b.s. electrical engineer degree.
Checked all the wires, i even tried connecting the driver side alp to the "center alp connector", didn't change a thing.
Here's some clips of today, i wish i could combined them all for you:
.(Once i cover the driver side alp, i get a series of beep)