ALPS Integration with V1 and alerting on ALPConnect

[jfr3170]

I am having an AL Priority quint system installed along with the AL Priority Radar/GPS module V2, the AL Priority GPS antenna, and the AL Priority HiFi Control Set. I am also having the AL Priority Bluetooth Module installed and will be able to switch between it and the HiFi Control Set via an RJ-45 switch. I am currently planning on integrating my Valentine 1 with the AL Priority system. My V1 is already programmed with Custom Sweeps, and I have the TMF2 turned on to cut down on blind spot radar K-band alerts. I also have access to a V1 connection LE in another vehicle if needed to change any V1-only programming.

I would like to maintain the custom sweeps and TMF2 when the V1 is integrated with the AL Priority System. Which of the "Radar bands" options should I select? From a couple of other threads, it seems like I should select X-band, K-band, Ka-band, Euro Mode, Euro X Mode, and Filter, and leave the K-band and Ka-band options at Wide so that the V1 itself is still doing the custom sweeps I have programmed into it. Does this sound correct? If not, please advise what setting/settings should be changed? Thanks in advance.

[BestRadarDetectors]

I am having an AL Priority quint system installed along with the AL Priority Radar/GPS module V2, the AL Priority GPS antenna, and the AL Priority HiFi Control Set. I am also having the AL Priority Bluetooth Module installed and will be able to switch between it and the HiFi Control Set via an RJ-45 switch. I am currently planning on integrating my Valentine 1 with the AL Priority system. My V1 is already programmed with Custom Sweeps, and I have the TMF2 turned on to cut down on blind spot radar K-band alerts. I also have access to a V1 connection LE in another vehicle if needed to change any V1-only programming.

I would like to maintain the custom sweeps and TMF2 when the V1 is integrated with the AL Priority System. Which of the "Radar bands" options should I select? From a couple of other threads, it seems like I should select X-band, K-band, Ka-band, Euro Mode, Euro X Mode, and Filter, and leave the K-band and Ka-band options at Wide so that the V1 itself is still doing the custom sweeps I have programmed into it. Does this sound correct? If not, please advise what setting/settings should be changed? Thanks in advance.

Your are correct. Just keep everything on wide and ALP will not filter any results but your sweeps will be doing all the work on the V1 end.