I think you must utilize the exact instructions for application straight from Bob's website. This is presented to the masses as the application required to get protection. You vary from the published application instructions and you now own the results versus VEIL owning the results. Follow VEILS instruction.
In my humble opinion.
Veil G5 is a water-borne transparent acrylic latex polymer coating that is applied with a foam brush (included). VEIL is easily applied to the most reflective surfaces of your automotive vehicle including its headlights, fog lights, brake lights, directional indicators, and number plate areas.
A single application is sufficient to effectively cover these areas.
Note: Veil G5 can now safely be applied directly to your license/number plate however, we recommend applying Veil to a clear license plate cover as blocking performance tends to improve while be more discreet in appearance. Veil can be thinned with water to allow lighter coatings to be applied either with the brushes provided or with an airbrush. Two light coats tend to perform better than one heavier coat. We’ve experimented and have found that coating the front and the back of a clear plate cover or applying a light coat directly to the plate coupled with a light coating on a plate cover provides potentially better blocking efficiency while being less noticeable to the naked eye.
Publish your results following VEILS application instructions to the letter. VEIL owns those results.
From there you may get a mop and smear the entire front of the car and test.
You own those results.
Connect With Us