help with installation

[ROCKEY]

Thanks man! Great insight

[ROCKEY]

Great! Thanks

[TurboDriver]

So even though this is a big shiny truck you can still have great protection even with a few weak spots, let me explain.

The most likely first or initial shot from LEO will be front and center, that big grill shouts "hey look at me". You will likely have a few seconds before the shooter starts panning around to get a lock and makes it over to lights or fogs. A good slow and kill (JTK) should be accomplished by then, and you're good to go.

We strive to get jam to gun (JTG) in testing, and that is great for peace of mind, but in the real world a few seconds is all we really need or all we should really use.

[ROCKEY]

So even though this is a big shiny truck you can still have great protection even with a few weak spots, let me explain.

The most likely first or initial shot from LEO will be front and center, that big grill shouts "hey look at me". You will likely have a few seconds before the shooter starts panning around to get a lock and makes it over to lights or fogs. A good slow and kill (JTK) should be accomplished by then, and you're good to go.

We strive to get jam to gun (JTG) in testing, and that is great for peace of mind, but in the real world a few seconds is all we really need or all we should really use.

Thanks!

[ROCKEY]

I would NOT put them in the bottom of the bumper, There good but not that good LoL, You would need to put them in the upper portion.... if that is NOT an option then i would suggest putting in the lower and get tested right away to be sure.
But i really dont think there going to cover you down there

Thanks man! This helps

[ROCKEY]

That would be my pick :
Attachment 3104

Great! Appreciate your input

[ROCKEY]

if the grill is part of the hood...can you run the wires down along the (underside of) hood, down the hinges to the firewall. So opening and closing the hood is an option.

Thank you!

[ROCKEY]

When YC or BRD sees this thread they'll be able to let you know if the lower position is possible.
But, iirc, the center head needs to be on a higher or lower plane than the other two sensors due to interference issues.
One of RALETC guys or BRD will be along to help shortly I'm sure.

Thanks

[ROCKEY]

I'd be afraid that impact of closing the hood would adversely affect the heads (placement going out of whack overtime)..

I suppose that if you close the hood gently, it shouldn't matter..

Great insight! Thanks

[Tman]

From what i read , the heads perform better
when aligned horizontally in the same plane,
as per Tom's recipe....hope i learned well :-!