RALETC LIDAR Jammer Testing Meet. September 21

[specifics]

Ya, sure you were!

I did finally figure out the cruise control..... an achievement in of itself... haha

[Christoph_Kohl]

http://www.raletc.com/2014/09/raletc...sting-results/

Thanks Mirage for posting the results! I wanted to clarify a small detail though.
My vehicle had no veil on the front. I believe it was "fox in the hole" that had tonnes of VEIL on the front of his subaru...

[spankyaf]

http://www.raletc.com/2014/09/raletc...sting-results/

Thanks Mirage for posting the results! I wanted to clarify a small detail though.
My vehicle had no veil on the front. I believe it was "fox in the hole" that had tonnes of VEIL on the front of his subaru...

Yeah and let's be clear it was the absolutely the ugliest install I've ever seen ... sort of like his kids finger painted it on. But then again maybe he's on to something

[spankyaf]

Gotcha, I do have my tag light housing that protrudes between the rear sensors.
It wasn't so much that BRD advised me to do that, as I thought about it and asked if it was okay, just didn't want to give the impression that conflicting advice had been given.

Thanks for the reply.

Seriously if you want to obsess about something think about your helmet and your jacket

[FJR1300]

Seriously if you want to obsess about something think about your helmet and your jacket

Not obsessing, just noticed the sensors on the same plane mentioned in Mirage's write up. I was JTG & JFG with single F & R sensors before with Ga Speed shooting so I'm expecting the quad setup should still be good but haven't had an opportunity to test against vpr yet and at the speeds I like to travel...maybe I do obsess a little

Helmet & jackets are black with no reflective material and all bike reflectors removed btw.

[BestRadarDetectors]

Not obsessing, just noticed the sensors on the same plane mentioned in Mirage's write up. I was JTG & JFG with single F & R sensors before with Ga Speed shooting so I'm expecting the quad setup should still be good but haven't had an opportunity to test against vpr yet and at the speeds I like to travel...maybe I do obsess a little

Helmet & jackets are black with no reflective material and all bike reflectors removed btw.

Your install on your bike is perfect. Mirage was referring to a truck install where the center sensor was mounted over 1 1/2 feet lower than the other two sensors near the headlights.

[RedRocket]

http://www.raletc.com/2014/09/raletc...sting-results/

My vehicle had no veil on the front. I believe it was "fox in the hole" that had tonnes of VEIL on the front of his subaru...

Correct - Dark Blue & heavy coating of Veil on the Subie made a big diff. for him.

[spankyaf]

Not obsessing, just noticed the sensors on the same plane mentioned in Mirage's write up. I was JTG & JFG with single F & R sensors before with Ga Speed shooting so I'm expecting the quad setup should still be good but haven't had an opportunity to test against vpr yet and at the speeds I like to travel...maybe I do obsess a little

Helmet & jackets are black with no reflective material and all bike reflectors removed btw.

What colour do you guess my helmet was?

[FJR1300]

What colour do you guess my helmet was?

Valentino Rossi yellow? I get what you're saying, my helmet was targeted with the non vpr guns including the TSS, iirc Ga Speed got one pt @ 90 ft, once.

[NYSpeederPVM]

Chris kohl's grill was all black but that was plastidip? And yeah fox in the hole had lots of veil, not so evenly painted on but it certainly seemed to work.