RALETC LIDAR Jammer Testing Meet. September 21

[Mirage]

You mentioned that a 3rd head should be on the same plane as the other two. Would this mean that all dual front or all dual rear heads should also be on the same plane?
I set up my rears with the left rear slightly higher than the right to try and account for different angles between level and overpass shots. BRD thought this was fine at that time, has further testing shown this not to be the case any longer?

you are a special case with a small footprint I probably wouldn't recommend that for you. BRD and I talk about this stuff quite a bit so if he told you to do something then I would stick with it.

With respect to this test the user had a triple setup with 2 heads on the upper part of the front facia and 1 head in the lower portion of the grille. This is not optimal because you increase the risk of cross talk between the sensors.