Close
Results 1 to 10 of 67

Thread: "Error 2"

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #10
    Senior Member RedRocket's Avatar
    Join Date
    Nov 2013
    Location
    North America
    Posts
    2,057
    Thanks Given
    1,081
    Thanked 1,543 Times in 846 Posts
    Quote Originally Posted by BestRadarDetectors View Post
    Is everyone receiving Error 2 running HFi? Hifi does consume a lot more current than the standard controller. If install is not solid with good solid power connections we have seen some strange errors.
    Ok,I took another look at my Error 2 situation moments ago.

    For me it is definitely caused by the proximity of the Lilac bush near the Front of my car where I normally park in my driveway.With my Parking "set-point" at #3 in the Set-Up table I cannot get any closer than 19-20ft spacing distance to that Lilac bush (& most likely any other object) when powering "ON" the Priority.Besides the double red LED flashing,the HiFi audio reports - "Error 2,lose or disconnected wire cable or defective sensor" !

    I also found the Priority WILL NOT power "OFF" (when in Error 2 state) by holding down the power button on the Control Set pad.I had to pull the fuse that is in the +12v feed to the Control Box(CPU).I rolled my car backwards increasing the spacing distance to the bush to ~25ft...re-inserted the fuse & powered "ON" the Priority & it booted-up w/o the Error 2 just as it should.

  2. The Following User Says Thank You to RedRocket For This Useful Post:

    modsl55amg (02-20-2015)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •