Close
Results 1 to 10 of 67

Thread: "Error 2"

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #19
    Senior Member FJR1300's Avatar
    Join Date
    Mar 2014
    Location
    FL
    Posts
    476
    Thanks Given
    227
    Thanked 314 Times in 149 Posts
    Most vehicle electrical problems start out with a bad ground, looks mean nothing. Best way to test your ground is via voltage drop, measure from a known good ground, use the battery terminal for convenience, the other lead at the ground point you are considering.
    Max reading is .5 volts, but even that is bit a high in modern cars, I recommend < = .2 volts.

    If you have that, the next thing to check is whether that voltage reading changes with temperature, if you have a multimeter with record fumction, you can just leave it hooked up and run the engine for a while,, then let it cool back down and check your max readings.

    One common area that causes high voltage grounds on the entire vehicle is the negative cable where it connects to the engine block, particularly in snowbelt vehicles.

    If your multimeter has an ammeter function you can take recorded readings of that also (as long as you're tapped into a power source rated <= the ammeter capability)
    Hth.
    .

  2. The Following User Says Thank You to FJR1300 For This Useful Post:

    modsl55amg (02-20-2015)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •