AL Priority Firmware Update History (Running History)

[BestRadarDetectors]

Ok so i have a few questions.. Im sure it is in this thread some where but didnt feel like going thru 25 pages to find it... I know shame on me ..... So i did the up date and i guess it went fine, but now when i check the sensors it is coming up F2F3 and R1R2? should it say F1F2?.. I check the sensors and they all seem to be operating as they should.
Next thing, I wanted to set it up so that if im not moving that they are just parking sensors, So if i go thru some place where they now allowed i can just show that they are just parking sensors.. So can someone please tell me what Define pdc speed limit is and define LID speed limit, I know that LID time is the length you set for the system to go into just receive mode...
I came to the understanding that the LID speed time was so that it will only alert when above the set speed, Which i set it for 12 and then hit it and it went off as if was set to None...

You found the only bug that we realized with the new firmware. Nothing is wrong with your setup but the ports were accidentally reversed when a check sensor is called (This was already corrected and will be fixed in the next upcoming update in a few weeks). F1 is listed as F3 and vise versa and R1 is listed as R2 and vise versa. In order to make the system act only as parking sensors when traveling under a pre-set speed you need to have the GPS added to the system. If you have GPS attached it will also only ignore alerts if a GPS signal is present. If it does not have a lock it will Jam to make sure you are protected if you lose GPS Signal so if testing in a garage etc with no GPS signal the unit will Jam.