AL Priority Firmware Update History (Running History)

[BestRadarDetectors]

Did the behavior of the parking sensors change with version 4.5.1? I got a solid red light on my ALP when pulling into the garage today. When I pushed the POWER button once, the light went to flashing (and the parking sensor beeps started up). One more press of the POWER button and the light was back to solid red.

Short press on the power button turns the parking sensors on or off. This was always that way. You might have turned them off previously not realizing it and when off the light will illuminate with no sounds.

[awj223]

Short press on the power button turns the parking sensors on or off. This was always that way. You might have turned them off previously not realizing it and when off the light will illuminate with no sounds.

But previously, the light would flash (same as with the sounds on). Closer objects = faster flashing. However, this time it was a solid red light.

[BestRadarDetectors]

But previously, the light would flash (same as with the sounds on). Closer objects = faster flashing. However, this time it was a solid red light.

Correct but only when turned off. When back on it should act normally with the timed flashes and quicker sounds as you get closer.

[awj223]

Correct but only when turned off. When back on it should act normally with the timed flashes and quicker sounds as you get closer.

Why was the flashing red changed to a solid red? With the old firmware, I could at least tell how far I was from an obstacle by looking at the light (even with the sound turned off). With the solid red light, I cannot do that.

[BestRadarDetectors]

Why was the flashing red changed to a solid red? With the old firmware, I could at least tell how far I was from an obstacle by looking at the light (even with the sound turned off). With the solid red light, I cannot do that.

Not sure and I dont really know when it changed. It most likely had to do with changes to make all the new stuff compatible with each other.