First Steps Required After Installing Your AL Priority System

Quote:

---

Originally Posted by Dr86

System is powered on, I insert USB memory drive with firmware, UCSET.bin, setup.alp, nothing happens. USB drive light doesn't light up, ALP just blinks normally (blue, one per second), no red error blinking, no multicolor firmware upgrade blinking.

---

The page states that the file should be named Setup.alp and you have it without the capitol letter S, dunno if that matters tho.

Quote:

---

Originally Posted by MagicOnline

The page states that the file should be named Setup.alp and you have it without the capitol letter S, dunno if that matters tho.

---

I didn't change the name of the file, I just downloaded onto my USB key whatever it was straight from ALP's website. Thanks for the suggestion though.

BRD, is it recommended that ANY time you do a firmware/control set update or change the setup parameters, should you do a factory reset again?

Quote:

---

Originally Posted by Qui-Gon

BRD, is it recommended that ANY time you do a firmware/control set update or change the setup parameters, should you do a factory reset again?

---

Yes, I would run a factory reset to make sure your sensor positions are always current after a firmware update.

Quote:

---

Originally Posted by BestRadarDetectors

Yes, I would run a factory reset to make sure your sensor positions are always current after a firmware update.

---

Do you need to do this if you're just updating your setup preferences, i.e. PRO Mode, LID time, DARK mode, etc.?

Quote:

---

Originally Posted by Qui-Gon

Do you need to do this if you're just updating your setup preferences, i.e. PRO Mode, LID time, DARK mode, etc.?

---

No, Only CPU Firmware.

Quote:

---

Originally Posted by BestRadarDetectors

No, Only CPU Firmware.

---

Thank you for the clarification! :thumbs2:

Is it not possible to just hook your computer straight to the CPU and update it as you do the LIs or is it necessary to use a flash drive?

Sorry I am sure I am going to be asking a lot of dumb questions over the next while since I just ordered my ALP and will be doing plenty of research to get ready for it.

Quote:

---

Originally Posted by Dr86

Firmware number is 4.3.1. The other thing is I can't pull any stats using menu 7-2-2-2 either. Is it possible that the first time I ran the update sequence (where it was blinking multiple colors and rebooted) using the firmware .bin file I downloaded before registering my serial number with ALP somehow bricked my system? Everything else seems to be working (parking sensor, control set etc), just not USB.

---

Any chance you are mixing up the next and enter buttons when using 722 for stats, don't ask how I know that's possible ;)

Sent from my SAMSUNG-SM-N900A using Tapatalk

Quote:

---

Originally Posted by FJR1300

Any chance you are mixing up the next and enter buttons when using 722 for stats, don't ask how I know that's possible ;)

Sent from my SAMSUNG-SM-N900A using Tapatalk

---

Nope, because I get into the service menu (white led) and right beep sounds after I enter each 2. Except at the end, instead of blue blink indicating stats downloaded, I get a red blink.