ok thanks, but will be in morn when i wake up
Printable View
ok thanks, but will be in morn when i wake up
Ok, Emailed you a copy of the last version 3.1, There might be an issue with the 3.2 on the website. Some are having trouble with it.Quote:
Originally Posted by dinkydi
ok thanks got it , ready and waiting on usb, pm sent thx, will install the standard way
just the same
Serial number 2134299
Firmware version 4.3.6
Region Australia & Pacific
Power Cycles 401
Control Set FW version 1.4
Control Set HW version 4
going on road test,
one silver lining the htp works great through the car speakers :courage:
Will finish with you though PM.
Sent from my SCH-I605 using Tapatalk
How do you initiate "write setup do USB", over the iPhone or Control Set (Yellow menu / 7 - service codes / 2 - 2 - 2 ) ?
They Are two separate ones as I found out thx to brd
For the controller follow instruction statistic on the alp update site
For bt scroll the menu on phone down load to usb
I have to say I do like the new K band alert no where near as annoying as the old one.
Sent from my Nexus 7 using Tapatalk
So if I haven't updated my control box to 3.2 from 3.1 yet, should I wait?Quote:
Originally Posted by BestRadarDetectors
I've been enjoying the ALP Connect currently.
If you are using ALP Connect you do not need to update the Control Set.Quote:
Originally Posted by jdong
Sent from my SCH-I605 using Tapatalk
Right, I've got both on the recommended manual switch, so I might use the control set in the future. If the only useful changes are some volume adjustments and K band tones... I can do without it.Quote:
Originally Posted by BestRadarDetectors
Yep great and only announced once with the red warning still onQuote:
Originally Posted by dragons
I don't get what your trying to say here dinkyQuote:
Originally Posted by dinkydi
Sent from my Nexus 7 using Tapatalk
just agreeing with what u said and the k band warning, dont know if mine is different, but as i said it just voice announce once only, but the warning led light stays on until k threat is passed
Oh ok..
I Don't use the BT module only the control set as default.
Sent from my GT-I9305T using Tapatalk
When you use ALP Connect reported Control Set version is actually ALP Connect version (1.4) and hardware version is 4 (that means that you use ALP Connect).
If you want to check your control set version you have to use Control Set. ALP can't poll Control Set for firmware version if it's not connected to it!