New Dragon guns out ?

Quote:

---

Originally Posted by Z062015

I just pulled a tape along the contour of the front and it was 25 1/2" between the sensor. It looked like 24 3/4" actually between the inside edges of both sensors. If you think that's the problem I can move them closer together or if it would be better buy another sensor.

---

I measure center-of-bubble to center-of-bubble b/c the receiving function is the more critical function in this case.
That makes you close to 27" & a primary factor I believe.

It's around 26 1/4" on the front and 23 1/2 on the back. The bubble is inboard on the front and outboard on the rear. Does it matter how they are oriented? Thanks.

Thanks for your help and advice Tom.

Quote:

---

Originally Posted by Z062015

It's around 26 1/4" on the front and 23 1/2 on the back. The bubble is inboard on the front and outboard on the rear. Does it matter how they are oriented? Thanks.

---

Bubble orientation generally doesn't matter, the net effect is basically the 1 inch difference in bubble to bubble distance. The bubble is where the receiver is.

Quote:

---

Originally Posted by jdong

Bubble orientation generally doesn't matter, the net effect is basically the 1 inch difference in bubble to bubble distance. The bubble is where the receiver is.

---

Thanks. I'm going to remove and re-install the heads and make sure they are closer together and aligned and level. Once I get that done i'll try to get my hands on another dragoneye.