Issues installing new TX head

[machtschnell]

So I had an F2 and F3 sensor fail. I swapped cpu's in my vehicles and updated all firmware. Then I was only getting automatic senor check fail senor F2. The other vehicle runs fine. I had been debating on updating to a TX head for the front. (quint systems on both vehicles) so I used this as the opportunity to make the swap. I first tried plugging the TX head into the existing extension line to the cpu. getting same error code. so I run the new extension wire from the TX head to the CPU and getting the same error still. Any ideas on what to check next?

[machtschnell]

I should note also I tried using a different hifi connection and still the same issue.

[BestRadarDetectors]

I should note also I tried using a different hifi connection and still the same issue.Did you run a factory reset to memorize the hardware change. Anytime you change any hardware you need to run a factory reset or you will get a sensor check fail because your. Hardware configuration changed. TX Sensors also can only be used on #2 ports so in the front it needs to be plugged into the F2 port.

Sent from my SM-N960U using Tapatalk

[machtschnell]

Feeling really stupid right now...it’s set and working thanks.


Sent from my iPhone using Tapatalk