Close
Results 1 to 5 of 5
  1. #1
    Junior Member
    Join Date
    Nov 2015
    Posts
    20
    Thanks Given
    1
    Thanked 3 Times in 2 Posts

    Help new install and stuck on two red beeps!

    Went to do a factory reset and my new system freshly installed will not go into yellow led menu mode. I have tried a variety of things. I have even plugged in the usb with the initial files and powered up then down then up and still to no avail. Does anybody now how to get around this? Is it truly the cables are not fully plugged in or crimped or bad sensors? My installer installed the. Control unit under the foot well so I have to tear that apart to get to it.
    Thanks for the help.
    Cheers,
    Chris

  2. #2
    Senior Member
    Join Date
    Jul 2015
    Location
    California
    Posts
    131
    Thanks Given
    141
    Thanked 18 Times in 16 Posts
    Do you have any led lights come on?

  3. #3
    Senior Member BestRadarDetectors's Avatar
    Join Date
    Oct 2013
    Location
    NJ
    Posts
    4,503
    Thanks Given
    472
    Thanked 5,550 Times in 2,134 Posts
    2 Beeps that does not stop is usually when no sensors are attached. Please check the sensor wiring and make sure the sensors are plugged into the CPU and the sensor connectors near the sensors themselves are plugged in and then twist locked.
    Need Help Choosing a Radar Detector for your needs? Visit our website: http://www.bestradardetectors.net, Send us a PM or call us at 1-888-229-7594
    Before looking at an Escort Radar Detector you should really check out Uniden Detectors.. Uniden R1 & R3 are the best performing radar detectors for the money.

  4. The Following User Says Thank You to BestRadarDetectors For This Useful Post:

    modsl55amg (11-20-2015)

  5. #4
    Junior Member
    Join Date
    Nov 2015
    Posts
    20
    Thanks Given
    1
    Thanked 3 Times in 2 Posts

    Help new install and stuck on two red beeps!

    Thanks all lights come on. I will tear apart the car in the morning to check the connections.
    The light sequence is green then a long red and the two reds continuously


    Sent from my iPhone using Tapatalk
    Last edited by driggett; 11-20-2015 at 10:31 PM.

  6. #5
    Junior Member
    Join Date
    Nov 2015
    Posts
    20
    Thanks Given
    1
    Thanked 3 Times in 2 Posts

    Help new install and stuck on two red beeps!

    Took off the floor cover for the dash and took out the cubby and could see in there. Good job of wiring by the installers. Played around with the sensors, made sure all cables were plugged in and in the end the installers had place the gps cable at the wrong end of the box. Disconnected it and Lo and behold it worked. I plugged the gps cable in the right end and still works. Mentioned it to the installers and they will help me out in a future purchase or need so that was good. I feel sorry for them though because it took them supposedly 14 hours to put in all the components and I bet they were stuck for at least a couple of hours on this problem.


    Sent from my iPad using Tapatalk
    Last edited by driggett; 11-21-2015 at 01:55 PM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •